Tektronix TekSeriesScope IVI Driver v 1.2 for 5 Series Mixed Signal Oscilloscopes. Installation Instructions The installation of the IVI-COM driver requires the IVI Foundation Shared Components to be pre-installed. This download includes the version of the shared components v 2.4.1, that the driver was developed with. Newer versions of the shared components will work with this driver. Older versions will not. This distribution includes the shared components clean-up utility that should be used whenever removing and replacing these components. Running "CleanupUtility.exe" when shared components are not installed will simply result in an information message. Click through this and then install the shared components. After installing the Shared Components, you can install the IVI-COM driver. 1. Download the TekSeriesScope1.2.0.exe file to your PC hard drive. Launch the self-extracting executable file. You will be prompted to select a destination folder. Following extraction, the selected location will have a "TekSeriesScope1.2.0" folder. This folder will contain two directories: "x86" which has installers that run on 32-Bit OS and "x64" which has installers that run on 64-Bit OS. Each of these will contain two sub directories: one is named "IVI-COM Driver" and the other, "Shared Components". 2. Close the programs running on your PC. 3. Uninstall any previously installed version of Shared Components on the PC. 4. To uninstall the Shared Components run the IviCleanupUtility.exe in the "Shared Components" directory. Double click on this program to uninstall a currently installed version of the shared components. If there are no shared components installed you will be notified with a message box. Simply dismiss the message box and continue with the Shared Components installation. 5. To install the IVI Foundation Shared Components run the program named IviSharedComponents.exe which is located in the "Shared Components" directory. 6. After the Shared Components are installed, run "TekSeriesScope-x64.msi" in the "IVI-COM Driver" directory under the "x64" folder to install the Tektronix TekSeriesScope IVI-COM Driver on a PC with 64-Bit OS or "TekSeriesScope-x86.msi" in the "IVI-COM Driver" directory under the "x86" folder to install the driver on a PC with 32-Bit OS. NOTE: If you have successfully downloaded this software but are unable to complete the installation per the instructions above, please contact the Tektronix Technical Support Center. Customers calling within the U.S. call 1-800-833-9200 (customers calling from outside the U.S.call 503-627-2400).