TekExpress M-PHY TX Automated Solution (v10.1.0)

Product: TekExpress M-PHY TX Automated Solution
Version: 10.1.0
Date : 16Dec2019

Installation Instructions.
================================================================================
Minimum System Requirements
Oscilloscope : Tektronix DPO/DSA/MSO70000/C/D/DX series oscillscope >= 6GHz
Operating System : Windows 10 .
Hard Disk : Approximately 2.2 GB of available hard-disk space for the recommended installation, which includes full TekExpress installation and distributed components.
Software :
:TekScope Firmware version 10.10.0 or above 
:Jitter and Eye analysis tool (DPOJET Ver 10.0.11 or above) with DJAN enabled
: SDLA v3.0.4.3
: Microsoft Internet Explorer 6.0 SP1 or later.
: Microsoft Photo Editor 3.0 or equivalent software for image files viewing.
: Adobe Reader 6.0 or equivalent software for viewing portable document format (PDF) files.
================================================================================
Installation
1 TekExpress M-PHY Tx
i. Download TekExpress_MIPI-M-PHY-Tx.exe
ii. Close Tekscope or any other running application.
iii. Run the TekExpress_MIPI-M-PHY-Tx.exe program which will unzip and follow the installation wizard to install the application. 
iv. After restart of the oscilloscope, Go to Analyze menu to launch TekExpress M-PHY TX compliance application solution.
================================================================================
If for some reason you are unable to download or install this software
please contact the Tektronix Technical Support Center:
Customers calling within the U.S. call 1-800-833-9200 press 3.
Customers calling from outside the U.S. call 503-627-2400.

---End of File---