Deployment Package for Version 10.7.0 Firmware.

Version: 10.7.0
Date : July 27, 2017

IMPORTANT NOTE: Please do not rename the downloadable executable!

Installation Instructions.
================================================================================

Minimum System Requirements

Oscilloscope:
DPO77002SX

Operating System: Windows 7 Service Pack 1

Hard Disk or Solid State Drive: Approximately 4 GB of available disk space for the recommended installation


================================================================================

1. Installation:

Description: The Deployment Package WEB installer "DeploymentPackage_V10_7_0_DP15_066141826.exe" is used to install
the Tekscope and several applications on a supported oscilloscope with a single click.
For the list of compatible instruments see the "Supported oscilloscopes" section below:

Steps to download and install the Deployment Package.

i. Download the DeploymentPackage_V10_7_0_DP15_066141826.exe file from the Tektronix.com Website.
ii. If you have downloaded the WEB installer on a PC, copy the file to the oscilloscope.
iii. Double click on the DeploymentPackage_V10_7_0_DP15_066141826.exe and follow the installation
wizard to install the application.
iv. If during installation you see a popup message regarding "file 'xyz' does not match the file in the setup's .cab file" you may have faulty copy of the software package.
v. To verify if your copy is valid run a MD5 checksum program and compare that value against the one included in the download. If they do not match delete the failing software package and re-download and try to install again. If the problem persists contact Tektronix Technical Support Center at the indicated phone number below.

==================================================================================
Note: The above installation process will take around 45 minutes and the Oscilloscope
will reboot automatically 2 times in between. On completion of the installation, the
Tekscope will be launched automatically.
The installation of this version will fail unless a previous version of TekScope is
installed on the instrument.

================================================================================
2. Supported Oscilloscopes:
DPO77002SX

================================================================================

If for some reason you are unable to download or install this software,
please contact the Tektronix Technical Support Center:
Customers calling within the U.S. call 1-800-833-92001-800-833-9200 press 3.
Customers calling from outside the U.S. call 503-627-2400.

---End of File---