SignalVu Vector Signal Analysis Software V3.8.0108
Scope firmware version 6.1.0 or higher and the Windows 7 64-bit system is required
to operate this version of SignalVu.
The software may reside on the hard drive of your Tektronix
Oscilloscope and on the Optional Applications Software DVD
received with your oscilloscope. The web download file may be
newer than either your oscilloscope or DVD version.
When the SignalVu application is loaded on your oscilloscope, the
application can be started from the oscilloscope menu:
Analyze -> SignalVu Vector Signal Analysis Software, or by selecting
the SignalVu desktop icon.
Free Trials
-----------
This software download offers free trials of the SignalVu
application for evaluation. Once the free trials are exhausted,
a software security key may be purchased from Tektronix to permanently
enable the software application on your oscilloscope.
SignalVu may be ordered as:
Option SVE - Signal View Essentials, Vector Signal Analysis Software
Option SVM - Signal View Modulation, General Purpose Digital Modulation Analysis, requires SVE
Option SVP - Signal View Pulse, Advanced Signal Analysis Software, requires SVE
Option SVT - Signal View Settling Time Measurements (Frequency and Phase), requires SVE
Option SVO - Signal View OFDM Measurements (7kC/70kC models only), requires SVE
Option SVA - Signal View AM/FM/PM Audio Signal Analysis, requires SVE
Option SV23 - WLAN 802.11a/b/g/j/p Tx measurements, requires SVE
Option SV24 - WLAN 802.11n Tx measurements, requires SV23
Option SV25 - WLAN 802.11ac Tx measurements, requires SV24
Option SV26 - APCO P25 measurement application, requires SVE
Option SV27 - Bluetooth LE and Bluetooth Basic Rate RF Measurements, requires SVE
Option SV28 - LTE Downlink RF measurements, requires SVE
Option SV30 - IEEE 802.11ad SC wideband waveform analysis, requires SVE
Step-by-Step Instructions
-------------------------
1. If your oscilloscope is not connected to the network, then
download the installer file to a personal computer and make a CD
OR place the file on a file server accessible to your
oscilloscope OR copy the file to a USB memory stick or thumb
drive. Copy the file to the oscilloscope Desktop and then
proceed with step 2.
2. If the scope application is running, close it by choosing
the red X in the upper right corner or by selecting File > Exit.
3. Run the SignalVu installation program. Follow the on-screen
instructions to complete the installation.
4. Once the application in successfully installed, remove the
installer file from your oscilloscope desktop.
If for some reason you are unable to download or install this
update, please contact the Tektronix Technical Support Center:
Customers calling within the U.S. call 1-800-833-9200 press 3.
Customers calling from outside the U.S. call 503-627-2400.
www.tektronix.com/oscilloscopes
www.tektronix.com/rtsa