Prerequisites ------------- - Oscilloscopes: - DPO/DSA/MSO70604C (Gen1 testing only) - DPO/DSA/MSO70804C (Gen1 and Gen2 testing only) - DPO/DSA/MSO71254C (Gen1 and Gen2 testing only) - DPO/DSA/MSO71604C (Gen1, Gen2, and Gen3 testing) - DPO/DSA/MSO72004C (Gen1, Gen2, and Gen3 testing) - DPO/DSA72504D (Gen1, Gen2, Gen3 and Gen4 testing) - DPO/DSA73304D (Gen1, Gen2, Gen3 and Gen4 testing) - DPO/MSO72304DX (Gen1, Gen2 and Gen3 testing) - DPO/MSO72504DX (Gen1, Gen2, Gen3 and Gen4 testing) - DPO/MSO73304DX (Gen1, Gen2, Gen3 and Gen4 testing) - DPO71304SX (Gen1, Gen2 and Gen3 testing) - DPO71604SX (Gen1, Gen2 and Gen3 testing) - DPO72304SX (Gen1, Gen2 and Gen3 testing) - DPO73304SX (Gen1, Gen2, Gen3 and Gen4 testing) - DPO75002SX* (Gen1, Gen2, Gen3 and Gen4 testing) - DPO75902SX* (Gen1, Gen2, Gen3 and Gen4 testing) - DPO77002SX* (Gen1, Gen2, Gen3 and Gen4 testing) - DPS75004SX** (Gen1, Gen2, Gen3, Gen4 and Gen5 testing) - DPS75904SX** (Gen1, Gen2, Gen3, Gen4 and Gen5 testing) - DPS77004SX** (Gen1, Gen2, Gen3, Gen4 and Gen5 testing) **ATI channels are supported only for Gen5. *Non-ATI channels are only supported by TekExpress PCI Express. - AFG31252, AFG3252, and AFG3252C for Automated DUT Control. - AWG7102, AWG7122B, AWG7122C, AWG5014C, AWG5014B, AWG5002B, AWG5002C, AWG7082C, AWG70001A, AWG70002A for Automated DUT Control. - GRL PCIE34 PHY Test Controller with part number : GRL-PCIE34-P1 for Automated DUT Control. - Contact GRL at support@graniteriverlabs.com for support and quote@graniteriverlabs.com to request for a quote. - GRL PCIE34 PHY Test Controller with part number : GRL-PCIE34-P1 for Power Cycle the DUT (Add-In-Card) - Contact GRL at support@graniteriverlabs.com for support and quote@graniteriverlabs.com to request for a quote. - Keithley System S46T RF Microwave Switch Systems for x12 PCIe . - Gigatronics RF Switch 26GHz (8902-L-48TS26) for x16 PCIe . - TekScope Firmware v10.8 (Win7) and v10.10 or above (Win10) - DPOJET 10.0.7 (Win7) and v10.1.0 or above (Win10) - DPOJET PCIE: Ver. 10.5.0 - SigTest v3.2.0.3 for Gen1, Gen2 and Gen3 for CEM, U.2, M.2 Specs. - SigTest v4.0.42 for Gen3 and Gen4 Base. - SigTest v4.0.51 for Gen4 CEM and Gen5 Base.