Product: HDMI2.1 eARC Pattern installer Version: 1.0.0 Date: July 2019 eARC Pattern installer - When AWG is selected for 'Automated DUT control', this AWG file will help to toggle between various patterns. TekExpress Automation software can control the DUT using a Tektronix AWG and cycle it through the various bit rates and Presets that are necessary for the compliance test. This eliminates the error in manual approach. Supported AWGs (for Automated DUT Control) --------------------------------------------------------------------- AWG5202,AWG5204,AWG5208 Installation: ------------- 1. From www.tek.com download/copy the "Tektronix eARC Pattern solution.exe" to any AWG supported (as per list in this Release Notes) 2. Close & exit AWG application. 3. Run the Tektronix eARC Pattern solution.exe and follow the installation wizard to install the toggle pattern Deployment: -------------------- After installation, you will find the following folders under C:\Program Files\Tektronix\eARC\Rx and the following *.awgx files in them 1. HFR5-2-1(eARC RX Termination Supply Voltage Tolerance at TP1) a) HFR5-2-1_1Low.awgx(Low Bit rate) b) HFR5-2-1_2High.awgx(High Bit rate) 2. HFR5-2-2(eARC RX Differential Mode Swing Tolerance at TP2) a) HFR5-2-2_1Low.awgx(Low Bit Rate) b) HFR5-2-2_2High.awgx(High Bit Rate) 3. HFR5-2-4(eARC RX Differential Bit Rate Tolerance at TP1) a) HFR5-2-4_11Low-1000ppm.awgx(Low Bit rate) b) HFR5-2-4_12Low+1000ppm.awgx(Low Bit rate) c) HFR5-2-4_21High-1000ppm.awgx(High Bit Rate) d) HFR5-2-4_22High+1000ppm.awgx(High Bit Rate) 4. HFR5-2-5(eARC RX Differential Mode Eye Diagram Tolerance at TP1) a) HFR5-2-5_1LowC1.awgx(Low Bit rate) b) HFR5-2-5_1LowC2.awgx(Low Bit rate) c) HFR5-2-5_21HighC1.awgx(High Bit Rate) d) HFR5-2-5_21HighC2.awgx(High Bit Rate) 5. HFR5-2-6(eARC RX Differential Mode Duty Cycle Tolerance at TP1) a) HFR5-2-6_1Low.awgx(Low Bit rate) b) HFR5-2-6_2High.awgx(High Bit Rate) 6. HFR5-2-9(eARC RX Common Mode Input Swing Tolerance at TP1) a) HFR5-2-9_Low.awgx(Low Bit rate) And you will find a folder C:\Program Files\Tektronix\eARC\Tx under which the following folder and awgx files can be found 7. HFR5-1-13(eARC TX Common Mode Input Swing Tolerance at TP2) a) HFR5_1_13_133mV.awgx b) HFR5_1_13_240mV.awgx