Customer Release Notes for eDP - eDP Tx DPOJET Essentials Version: 10.1.0.6 Last Revised: May-2023 Product (s): eDP DPOJET Essentials ================================================================================= Contents: 1. Introduction 2. Features 3. Supported list of equipment and accessories 4. eDP created changes on your system. 5. Before you click "RUN" 6. Known Limitations 6.1 Installer related limitation 6.2 eDP related limitation ================================================================================= 1. Introduction The Tektronix eDP DPOJET Essential Option provides engineers an easy and fast way to debug and perform compliance testing for eDP Tx devices. eDP option supports: - eDP DPOJET Plug-in The MOI contains the procedure for installation and the detailed information on how to use the system. The MOI is located at C:\Program Files\TekApplications\DPOJET\eDP_Tx_DPOJET_MOI.pdf. This Readme.txt file contains additional information for the user. ================================================================================= 2. Features v10.1.0 - Added support to Windows 10 - Added SCPI commands set support for all measurements ================================================================================= 3. Supported list of equipment and accessories Tektronix MSO/DPO/MSO/DSA 70000 C/D/DX/SX and above. Minimum Requirement TekScope:10.14.0 and above DPOJET: 10.5.0 and above ================================================================================= 4. eDP created changes on your system eDP Option, a DPOJET Plug-in a) eDP can be launched from "eDP" menu under "Analyze" menu of Scope application menu b) Launching eDP option from Analyze menu will launch DPOJET application with the technology eDP selected. The dropdown will have eDP enabled only if the EDP option is enabled on the scope. c) eDP measurements on DPOJET do not have free trials. ================================================================================= 5. Before you click "RUN" a) Ensure that all the required instruments are properly warmed up, Signal Path Compensation (SPC) is performed, followed by calibration and cable Deskew. b) It is highly recommended to read eDP MOI before you click "RUN". c) Ensure that the following software is installed in your system. Tektronix Jitter and Eye Diagram tool Adobe Reader 6.0 or equivalent software for viewing portable document format (PDF) files d) On the Sx series scopes-DPO70000SX, after recalling a setup file manually update the Channel configurations based on the channels available on the scope. ================================================================================= 6. Known Limitations 6.1 Installer related limitation a) Required softwware is installed on C: only. b) User needs to have administrative privilege while installing the application. c) If DPOJET software is upgraded and/or for some reason the DPOJET software is uninstalled and then re-installed, please re-install eDP software. 6.2 eDP option related limitation a) User needs to have administrative privilege while running the tests. b) Custom measurement (Eye Diagram, MainLink Frequency, and Inter-Pair Skew) plots will not be available in the DPOJET report. The same can be retrieved from C:\Users\Public\Tektronix\TekApplications\EDP\Plots folder. c) Eye Diagram plot scale's lower section is blurred. d) For Inter-Pair Skew test, second source need to be provided as an explicit clock. =================================================================================