Release Notes
Product(s)      : TekExpress DDR 
Version         : 1.0.0
Last Revised    : May-2019
=====================================================================================

Contents:
1. Introduction
2. List of supported equipment’s 
3. List of supported test
4. TekExpress Application created changes on your system.
5. Recommendations
6. Known Limitations  	
=====================================================================================

1. Introduction

The Tektronix TekExpress DDR is an automated test solution for performing 
DDR3 and LPDDR3 tests.
=====================================================================================

2. List of supported equipment’s 

For DDR3 and LPDDR3 - MSO64

Scope Version : 1.14.13.xx or greater
=====================================================================================

3. List of supported test groups.

DDR3

a) Read Burst
b) Write Burst
C) Clock(Diff)
d) DQS(Single Ended Read)
e) DQS(Single Ended Write)
f) Overshoot/Undershoot
g) Clock(Single Ended)
h) Address command
i) Digital

LPDDR3

a) Read Burst
b) Write Burst
C) Clock(Diff)
d) DQS(Single Ended, Write)
e) Overshoot/Undershoot
f) Clock(Single Ended)
g) Address command
h) Digital
=====================================================================================

4. TekExpress DDR created changes on your system.

After first launch of "TekExpress DDR.exe" following changes take place in 
your computer.
a) "My TekExpress" folder is created under "My Documents" folder of current user
    NOTE: If a user with new login ID launches "TekExpress DDR.exe" ,
   "My TekExpress" folder is created under "My Documents" of the new user. 
b) "Untitled Session" folder is created under "DDR" folder when the 
   application is launched and will be deleted after proper termination of the
   application.
c) If user saves a session then all session files are saved under "DDR"
   folder accordingly. Note that each session has multiple files associated with it 
   and do not tamper with any of the session file(s) and/or folder(s) as this may
   result in loss of data or corrupted session files.
=====================================================================================

5. Recommendations

Ensure that all the required instruments are properly warmed up, Signal Path 
Compensation is performed and deskew is done. 
=====================================================================================

6. Known Limitations

a) The following cases are not supported for Pre-recorded mode
     - Digital measurements
     - Burst detection method as "Logic State + Burst Latency"
b) Differential probing should be used to acquire CS signal